To Next Page
L
lucasjasonAug 15, 2025
What to do if Seca 336 display StOP?
- JJohnny WalkerAug 15, 2025
If the message StOP appears on your Seca Scales, it means the maximum capacity has been exceeded. Remove the load from the scale.
What to do if Seca 336 display StOP?
If the message StOP appears on your Seca Scales, it means the maximum capacity has been exceeded. Remove the load from the scale.
What does Err:11 mean on Seca 336 and what to do?
If Err:11 appears on the display of your Seca Scales, it indicates that the scale has too high a load or too high a load in one corner. Try removing some of the load, or distributing it more evenly on the scale. You can also try restarting the scale.
What does Err:12 mean on Seca 336 and what to do?
If Err:12 appears on the display of your Seca Scales, it means the scale was switched on with too high a load. Remove the load from the scale and restart it.
What to do if Seca 336 Scales display bAtt?
If the display shows bAtt on your Seca Scales, it means the batteries have discharged. Replace the batteries.
Why Seca Scales show tEMP on the display?
If the display shows tEMP on your Seca Scales, it indicates that the ambient temperature of the device is too high or too low. Set up the device in an ambient temperature between +10 °C and +40 °C. Alternatively, wait approximately 15 minutes to allow the device to adapt to the ambient temperature.
How to fix Seca 336 Scales when no weight is displayed with a load?
If no weight is displayed on your Seca Scales when there is a load, check whether the scale is switched on. If it is battery operated, check whether batteries are inserted. If it is power supply operated, check whether there is a power supply.
What does Err:16 mean on Seca Scales and how to resolve it?
If Err:16 appears on the display of your Seca Scales, it indicates that the scale was caused to oscillate and was unable to determine the zero point. Try restarting the scale.
What to do if Seca Scales display Err:32?
If Err:32 appears on the display of your Seca Scales, it means an internal communication error has occurred. Try restarting the scale.
Why 0.000 does not appear before weighing on Seca 336?
If 0.000 does not appear before weighing on your Seca Scales, it could be because a load was already on the device before it was switched on. Remove the load from the scale. You can also try switching the scale off and then back on again.
Explains how the scale is powered by batteries or an optional mains unit.
Details on changing batteries and connecting the mains unit for power.
Step-by-step guide on how to correctly weigh a baby on the scale.
Details on the scale's automatic power-saving features.
Explains how to use the TARE function to exclude additional weights from the result.
How to freeze the weight display and retrieve the stored value.
Checks for scale power, mains connection, or zero setting issues.
Interprets symbols like '?', 'batt', 'SEOP', 'TEMP', 'Er:011', 'Er:012' for battery, load, or temperature issues.
General
