Seca 888 - Setting Up and Aligning

Model 888 13
GB
Power supply
The scale is powered exclusively by batteries. The scale works independently of the
mains, which is very handy for mobile use.
The LC display has a low power consumption – 120,000 weighing operations can be per-
formed with one set of batteries. When the battery voltage is no longer adequate,
bAtt
appears in the display.
– Carefully turn over the scale so that the
base of the scale is accessible.
– Push the battery compartment closure
towards “Batterie” and open the cover.
– Connect the cable to the holder and
batteries.
– Place the holder in the battery com-
partment.
– Close the cover and then turn the scale
back up the right way.
4. Setting up and aligning the scale
– Place the scale on a level surface.
– Undo the locknuts using the four foot
screws.
– Align the scale by undoing the foot
screws. The air bubble in the spirit level
must be right in the centre of the circle.
– Then re-tighten the locknuts.
Important!
The alignment of the scale must be checked and corrected if necessary every
time it is relocated.
spirit level