● The plot can be stopped with the "Pause" key at any time, for example allowing you to
adjust knife settings while still in the cut job.
● You can use the "OK" key to continue to run the cut job.
Settings and operation
Moving the cutting head
Pressing the arrow keys lets you move the cutting head left or right, as well as transport the film
forwards or backwards. The corresponding X and Y coordinates are shown on the display.
Setting the zero point
To set the correct starting point for cutting, move the cutting head and film using the arrow keys, so
that the knife is located in the front right corner of the film. Now confirm this zero point by pressing
"OK".
Secabo GmbH Hochstatt 6-8 85283 Wolnzach Germany mail@secabo.com www.secabo.com
12
To Next Page
Loading...