To properly place finger：Lay the finger flat right on the reader.
(Note: Finger nail should not exceed 5mm in length. Otherwise,
it will affect authentication).
● Unlock with code：Enter a valid 6 digit code, and press “√”
button.
To mask your code: Add any random digit before or after the
correct 6-digit code (at most 3 digits). The lock will open only if
the 6 consecutive digits of the valid code are entered. Press “√”
button to confirm when the code is less than 9 digits.
4) Add User：
Add Owner：Press →Verify owner 1's or owner 2's finger
or code→Place first finger 3 times→Place second finger 3 times
→Enter code twice.
Add Visitor: Press →Verify owner 1's or owner 2's finger
or code→Press 0→Place first finger 3 times→Place second
finger 3 times.
Note: 1. Code can't be 123456.
2. After owner finger is added successfully, press “←”
button to cancel code setting according to the voice prompt.
To Next Page
Loading...
