11
Connecting to a third party controller
To connect the unit to a 3rd party controller follow these
steps, also known as ‘inclusion’ in Z-wave terminology.
- Ensure the network LED is flashing on the SSR303, if
not follow the steps in ‘Disconnecting from a network’
first.
- Put the 3rd party controller into inclusion mode.
- Press and hold the network button on the SSR303
until the ‘ON’ LED’s start flashing.
- The SSR303 has been included onto the network
when the ‘OFF’ LED goes solid red.
NOTE: If the ON LED does not flash then the include
process has been unsuccessful.
To Next Page
Loading...
General