Direct Wall Mounting
Offer the plate to the wall in the position where the
SSR303 is to be mounted and mark the fixing positions
through the slots in the wall plate. Drill and plug the wall,
then secure the plate into position. The slots in the wall
plate will compensate for any misalignment of the
fixings.
Wall Box Mounting
The wall plate may be fitted directly on to a single gang
flush wiring box complying with BS4662, using two M3.5
screws. The receiver is suitable for mounting on a flat
surface only; it is not suitable for mounting on an
unearthed metal surface.
6
To Next Page
Loading...