Secure SSR303 - Page 15

15
Supported Device and command classes
Z-Wave Command
Classes Support
Description
Binary Switch Command
Class
Supports SET and GET to control the relay.
Oppose to the Thermostat Command class
there is no failsafe mode.
Multi Channel
Command Class (Ver 2)
This command is used to independently
access the two channels available on the
SSR303.
Note: All command classes are version 1 unless otherwise stated
Basic Command Class The Basic Command Class has been mapped
to the Thermostat Mode Command Class as
follows:
- Basic SET: Not Supported
- Basic GET: Thermostat Mode GET
- Basic REPORT: Thermostat Mode REPORT