Security Brands Advantage DKE - Advanced Programming and Configuration; Set Relay Output Time; Add Access Codes to Relay B; Configure Event Input

4 of 6
Model 26-500
QUICK START GUIDE
ADVANTAGE DKE
© 2021 Security Brands, Inc. All rights reserved.
QSG-26500-EN Rev. H (9/2021)
A2
Additional Programming (continued)
Sub Mode
Sub Mode
Sub Mode
1
Add Access Code(s) to Relay B
(To add multiple codes, enter each of them before pressing pound key)
01 12 5 1 2 5 1
Master Code AgainMaster Code
(1251 is default)
Keypad will sound
“good” tone when
complete.
Delete All Codes (Cannot Be Undone)
61 12 5 _ _ _
Seconds
(000–999)
Relay
(1 for A, 2 for B)
Master Code
(1251 is default)
double
beep
double
beep
_
Set Relay Output Time
712 5 _ _ _ _
Access Code
(4 digits; numbers only)
Master Code
(1251 is default)
NOTE: Green arrow indicates “good” tone on keypad.
Always wait for good tone before moving on.
Sub Mode
Sub Mode
Mode or Exit
(0–2 or # to leave
mode unchanged)
3
Relay
(1 for A, 2 for B)
_
1 12 5
Current Mode
(Unit beeps mode
number or makes no
beep when disabled)
Master Code
(1251 is default)
9
Configure Event Input
(Allows an external device to affect keypad operation or trigger a relay)
_
Set Mode 1, Mode 2, Disable, or Check Current Mode
Mode 1 - Remote Inactive Mode
Disables all Relay A codes when input is received from external device
Mode 2 - Arming Circuit Mode
Turns on keypad unit when input is received from external device
Mode 3 - Remote Open Mode
Triggers either Relay A or Relay B when input is received from external device
Mode 0 - Event Input Disabled
Mode
1 12 5
Current Mode
(Unit beeps mode
number or makes no
beep when disabled)
Master Code
(1251 is default)
9
Set Mode 3
Modes