Seeley MagIQtouch - Using Slave Controllers with MagIQtouch

32
|
SLAVE CONTROLLERS
Multiple MagIQtouch Controllers can be used to control individual
zones. In such installations there is always one “master controller”
located in a nominated “master zone”. All other controllers become
“slave controllers”.
In such systems certain principles that apply:
• If the master controller is set to OFF, no other zone can be
turned on.
• If the master controller is set to ON, zones can be turned on and
o󰀨 from the slave controllers.
• The primary operating mode (HEAT, COOL and FAN ONLY) is
dictated by the master controller and cannot be changed by a
slave controller.
• The SETTINGS menu in a slave controller will only display
options relevant for the applicable zone.
For Evaporative Cooling:
• The Master Controller is the only active controller.
• The set temperature or fan speed can only be modied by the
Master Controller.
For Gas Ducted Heating / Integrated Cooling:
• The secondary operating mode (MANUAL and PROGRAM) can
be selected for each zone from the master and slave controllers.
• The set temperature is unique for each zone and is set from the
controller located within the zone (either master or slave).
• No fan speed limit control is available. Fan speed is
automatically controlled by the heater to achieve the set
temperature.