Operating Manual
MG1/dw-00 page 19 / 20
en MG1/dw-00 / June 13, 2006 Rev. 10.1
IMPORTANT! When removing, please observe by all means:
• current accident prevention regulations
• regulations for handling hazardous substances
WARNING! Seals that have been used with hazardous substances must be properly
cleaned so that there is no possible danger to people or to the environment.
IMPORTANT! The packaging used to transport the seal must
• be identified with the relevant hazard symbol and
• include the safety data sheet for the product and/or supply medium
The order of disassembly to remove the mechanical seal out of the machine depends
on the design of the machine and should be determined by the machine
manufacturer.
• Remove the seal in the reverse sequence as described for assembly (set up).
Spare parts
• Only BURGMANN original spare parts must be used. Otherwise
" Risks of a seal failure, endangering persons and environment.
" The BURGMANN guarantee for the mechanical seal lapses.
• For a quick exchange a complete spare seal should be on stock.
Required details for enquiries and orders
For enquiries and orders the following details are required:
! BURGMANN commission no.
! Drawing no. of M.S. MG1/dw-00
dw = specified shaft diameter
! Part item no., designation, material, number of pieces with reference to the
drawing.
Address of headquarters product field FA
Standard Mechanical Seals
Burgmann Industries GmbH & Co. KG
Postfach 1240
D - 82502 Wolfratshausen
Germany
% +49 (0) 81 71 - 23 0
Fax +49 (0) 81 71 - 23 14 44
To Next Page
Loading...
