SEFA
®
France
Page N°13
PNEUMATIC EQUIPMENT
VER-321 JACK Ø100 C50 1
FIL-013 FILTER 1
MIN-015 PRESSURE REGULATOR 1
ELE-203 ELECTRODISTRIBUTOR 5/2 G1/8 1
PRESS COVERING
MOU-445 MOUSSE 9 mm 400 X 450 mm
PEDAL OPTION
PED-279 PEDAL 1
FIN-231 SECURITY MICROSWITCH 1
2. REPLACEMENT OF USED PARTS
- The mat in silicone mousse
a) Check that the plate is cold.
b) Make sure that the plate surface is properly clean. Possible use a soft solvent such as White Spirit.
c) Use a RTV-1 tube of glue to stick the mousse to the aluminium plate (NB : read the instructions on the
tube packaging).
d) The mat and the plate must be clean and dry before starting any gluing.
e) Spread a fine layer of glue in a homogeneous way on the plate and immediately apply the mat making
sure that there is no air lock (NB : an indented spatula similar to the one used to lay tiles would suit
perfectly).
f) leave to settle overnight at room temperature with slight pressure and without heat.
- Other parts
Get in touch with your retailer to evaluate their change or their repair.
3. MAINTENANCE
The S.E.F.A
®
heat presses hardly require any maintenance. To ensure a good functioning, follow the
preventive notice indicated below:
- Do not heat up objects which could deteriorate or even cut the silicone rubber or damage the teflon
surface of the heating plate
- Every so often and when the plate is cold, clean the machine with a clean cloth and white spirit (NB: as
this product is flammable, use with care and keep it away from any heat source)
- When the heating plate is hot and unused, keep it in open position.
DAILY : Clean the mousse and the heating plate surface (when cold) with a dry cloth or
impregnated with spot remover.
Check the air filter behind the bracket, drain it if there is too much condensation.
MONTHLY : Check the column and grease it.
ACCORDING TO THE USE : Change the mousse every six months.
USE BY QUALIFIED STAFF ONLY
4. POSSIBLE BREAKDOWNS
To Next Page
Loading...