Sefa PR 245 S - V. PRESS SETTINGS; 1. TEMPERATURE; PRESSING TIME SETTINGS; 2. PRESSURE ADJUSTMENT; 3. ADJUSTMENT OF THE BRACKET HEIGHT

SEFA
®
France
Page N°8
V. PRESS SETTINGS
USE BY QUALIFIED STAFF ONLY
1. TEMPERATURE / PRESSING TIME SETTINGS
To program these parameters in the control electronic card, use the keyboard situated on the front of the
machine.
a) TEMPERATURE SETTING
See also the instruction manual of the card provided with the machine.
b) TIME SETTING
See also the instruction manual of the card provided with the machine.
c) CYCLE STOP
2. PRESSURE ADJUSTMENT
The jack pressure can be modified according to the user’s need.
Use the pressure regulator situated on the filter behind the bracket. The pressure will be displayed on the
manometer’s dial at the front. Pull the head of the regulator upwards, then turn:
ª clockwise to increase the pressure,
ª anticlockwise to decrease the pressure.
3. ADJUSTMENT OF THE BRACKET HEIGHT
According to the type of the item to mark or to adapt to the accessories of the PR 245 S (ex. cap
accessory), the height of the bracket has to be modified. Turn the wheel situated on the column:
ª clockwise to lower the bracket,
ª anticlockwise to raise the bracket.
¾ Press on ”Temps”,
¾ Press on ”-” to decrease the indicated value
Or on ”+” to increase it,
¾ Press on ”OK” to validate your choice.
¾ Press on ”Température”,
¾ Press on ”-” to decrease the indicated value
Or on ”+” to increase it,
¾ Press on ”OK” to validate your choice.
¾ Press on ”STOP / Ok”,
The cycle of the press is interrupted.