CONTROLLER UNIT
61
11
11
CONTROLLER UNIT
• When working with the product, be sure to turn the power off. Working with the
power on may cause an electric shock or short circuit
• Be careful not to damage the wires. Damaged wires may cause an electric
shock, short circuit or present a risk of re
• Exercise due caution in performing soldering work. If soldering iron is handled
carelessly, there could be res or burns
• When fastening plastic parts, be careful not to tighten screws or nuts excessively.
If these are tightened to excess, parts could be damaged, resulting in injuries
from fragments, etc.
• After the unit has been disassembled and reassembled again, check carefully
to be sure that there are no gaps or rattling at the junctions and that the trigger
can be operated smoothly. If there are gaps or rattling, or if operation is not
satisfactory, the players could get ngers or hands caught, resulting in injury
• Be sure to inspect control unit surfaces for cracks and damage. Players could
be injured if they play when the unit is cracked or damaged
• Assemble so that there is no gap between the L and R covers. If there is a gap
or rattling, the players could get ngers or hands caught, resulting in injury
• There is a possibility that the electronic components on the IC Board may be
prone to damage by static electricity. Please make sure to discharge any build
up of static electricity from your body prior commencing any work
• Power OFF machine before commencing any work
To Next Page
Loading...
