66
www.seuservice.com
18-2 CONNECTING NETWORK CABLES
To enable network play, the hubs inside each of the game machines involved must be connected with
network (LAN) cables. Connect the hub inside one of the machines to the hubs in each of the other
machines using LAN cables. There is no need to connect the other machines to each other.
Do not connect LAN cables to game machines when they are not used for network play.
● Turn off the power and unplug the power cord from the outlet. Place the power cord so as not to damage
it while working.
● Move the machines so that they are lined up. Leave enough space on the back lid side of the machine to
perform the rest of the operations in this procedure.
● Pass the LAN cable through the edge holder (the rectangular frame-shaped plastic part.) Pressing down
on the edge holder from above will cause it to stretch elastically and open up.
● Plug the connector on the end of the LAN cable into port 2 or above on the hub. Port 1, located at the
front closest to the front lid, is connected to the CHIRIHO in the base interior.
Any of the ports 2 or above can be used to connect to any of the other game machines.
Since the hub in one machine will be connected to the hubs in each of the other machines via LAN
cables, only one machine needs to be fitted with enough LAN cables for all machines involved. The other
machines will only have 2 cable connections each.
● Once the machines have been linked for network play, line them up. Leave as much space as possible
between the machines.
● Connect the power cord and grounding wire for each machine.
To Next Page
Loading...
Need help?
General
