14
www.sauservice.com
1
SECURING IN PLACE (ADJUSTER ADJUSTMENT)
Make sure that all of the adjusters are in contact with the floor. If they are not, the
cabinet can move and cause an accident.
This product has 8 casters and 8 Adjusters. (FIG. 6. 2 a) When the installation position is
determined, cause the adjusters to come into contact with the floor directly, make adjustments
in a manner so that the casters will be raised approximately 5 mm from the floor and make sure
that the machine position is level.
● Transport the product to the
installation position.
● Have all of the Adjusters make contact
with the floor
. Adjust the Adjuster's
height by using a wrench so that the
machine position is kept level.
● After making adjustment, fasten the
Adjuster Nut upward and secure the
height of
Adjuster.
FIG. 6. 2 b ADJUSTER
FIG. 6. 2 a BOTTOM VIEW
* Note:Picture may differ from actual unit.
WARNING!
To Next Page
Loading...
Need help?
General
