10
www.seuservice.com
To prevent electric shock or IC Board malfunctioning, be sure to turn off
the power for the cabinet when installing or removing the IC Board.
Extraneous matter such as dust on the IC Board can cause the IC Board
to generate heat and result in a re due to short circuit, etc. Ensure the IC
Board surfaces are always kept clean.
Use NAOMI 2 for the cabinets compatible with JVS. Using NAOMI for
the cabinet other than those compatible with JVS can cause generation of
heat and a re.
Be sure to connect the IC Board and connectors completely. Insufcient
insertion can damage IC Board, etc.
For the IC Board circuit inspection, only the use of Logic Tester is permitted.
The use of ordinary testers is not permitted as these can damage the IC Board.
Do not subject the IC Board to static electricity when installing the IC Board
in the cabinet or when connecting wire harness connectors to the IC Board.
When soldering buttons, etc. to the wire harnesses, be sure to remove the wire
harnesses from the IC Board so as not to subject the IC Board to heat.
Using NAOMI 2 without the Shield Case can cause electric wave trouble. Be
sure to use NAOMI 2 together with the accessory Shield Case.
The monitor frequency corresponding to NAOMI 2 is 15 kHz or 31 kHz.
NAOMI 2 can not be used for the cabinet incorporating a monitor or projector
not corresponding to 15 kHz or 31 kHz.
1. HANDLING PRECAUTIONS
Concerning the display of JAMMA VIDEO STANDARD:
JAMMA VIDEO STANDARD adopted by NAOMI 2 is referred to as JVS. As against this
Standard, the conventional JAMMA STANDARD which employs 56P Edge Connectors
adopted by ST-V, etc. is displayed as Old JAMMA STANDARD.
The specic Manual attached to each game sometimes displays JVS as JV STANDARD, New
JAMMA STANDARD, or JAMMA 2 STANDARD against OLD JAMMA STANDARD as
JAMMA STANDARD, JS, etc.
The contents herein described are subject to change without notice.
STOP
IMPORTANT!
WARNING!
To Next Page
Loading...
Need help?
General
