*The charger indicator is red when charging and turns to solid green when fully charged.
If the temperature of the vehicle body exceeds 104°F (40°C), it cannot be charged normally. Please wait for the temperature to drop.
WARNING
ONLY use the original charger. Other types can burst and catch fire.
DO NOT charge if the battery is wet or damaged.
DO NOT connect the charger when the charging port or charging cable is wet.
How to Install the Battery
After charging the battery, please put it into the vehicle in the following steps:
1. Open the trunk by any of the following methods.
1. Use the key.
• Squeeze one brake lever and tap the NFC card on the dashboard.
• If the battery is in the vehicle, squeeze one brake lever and hold the custom button. If the battery is not in, press and hold the custom button, wait until
the E, F, as well as the phone connection signal light up, and then squeeze one brake lever while holding the custom button.
*Please enable the AirLock in the App in advance. Make sure the ECU battery is not empty. You can check the battery level in the App.
2. Put the battery in the vehicle, connect the battery power plug and close the trunk.
Learn to Ride
To Next Page
Loading...
Need help?
General