Segway PT i2 - Attaching the Handlebar

15
English
 If your Segway PT is already assembled, you may skip this
section and go to “Adjusting the Handlebar Height” on
page 25.
Attaching the Handlebar
Tool Required: Torque wrench with 3mm bit.
To attach the Handlebar to the LeanSteer Frame:
1. Make sure the Segway PT is unplugged and powered off.
2. Align the Handlebar in place against the LeanSteer Frame using
the alignment guides.
3. Position the Handlebar Clamp against the Handlebar.