24
Preparing the LeanSteer Frame
Tool Required: 3mm hex wrench, Torque wrench with 3mm bit.
The LeanSteer Frame is collapsed to its shortest possible length
when it is shipped. Assembly is required before adjusting the
Handlebar height for the first time. To extend and assemble the
LeanSteer Frame:
1. Remove the Height Adjustment fastener and clamp using the
3mm hex wrench.
2. Extend the upper bar of the LeanSteer Frame by sliding it up
from its storage position until the slot for the Height Adjustment
fastener is visible.
3. Reinstall the Height Adjustment clamp and 3mm fastener.
4. Tighten to 2.0 N-m (18 in-lbf).
To Next Page
Loading...
