Segway x2 SE - Page 107

105
Remove the Handlebar
Tool Required: 3 mm hex wrench
To remove the Handlebar from the LeanSteer Frame:
1. Make sure the Segway PT is unplugged and powered off.
2. Using the 3 mm hex wrench, remove the three fasteners that se-
cure the Handlebar Clamp to the LeanSteer Frame.
3. When you remove these fasteners and the Handlebar Clamp, the
Handlebar is released from the LeanSteer Frame.
Attach the Handlebar
To attach the Handlebar see "Attach the Handlebar" (p. 18).
Figure 65: Remove the Handlebar