Segway x2 SE - Page 147

Pre-Ride Checklist – i2 SE, x2 SE, x2 SE Turf
Perform the following checks on your PT before each ride:
ProTIP: Copy and post this page near your PT “parking spot” – check  the boxes off as you go down the list.
 Check tire pressure
15 PSI – i2
4 PSI – x2, x2 Turf
 Check for tire wear
i2 – center rib is worn flush with tire surface
x2 – diamond pattern on center rib no longer visible
x2 Turf – tire tread depth is less than 3/32” (2.38 mm)
 Power on PT, confirm battery level displayed on InfoKey is at 4 bars minimum
 Ensure there is no visible damage to the PT
 Check the LeanSteer Frame stands straight and upright as shown
 Check the LeanSteer Frame for tightness
Torque: 11 N-m
 Ensure rider mats are intact, secure, and free of debris