59
Empty Battery Condition
The PT notifies you of a pending empty Battery condition before starting a Safety Shutdown. An unhappy face icon displays on the InfoKey
Controller, the PT’s speed is limited, and the PT emits a warning tone.
Whenever the PT notifies you of a pending empty Battery condition, come to a controlled stop and safely step off of the PT before the Safety
Shutdown begins.
Table 10 shows the InfoKey Controller icon that displays when a pending empty Battery notification occurs. The table also describes the
recommended action you should take.
NOTE:
In some cases, old, cold, heavily used, or poorly maintained Batteries may develop a high resistance condition. This can cause a pending
empty Battery condition to occur even if the Batteries were recently charged.
Display Icon Description Recommended Action
The system has detected and
notified you of a pending empty
Battery condition (empty PT
Battery charge level shown).
Come to a controlled stop and safely step off of the PT before the
Safety Shutdown begins. Do not resume use of your PT until you have
charged the Batteries.
Table 10: Empty Battery Condition
To Next Page
Loading...
