8 [en] Quick Installation Guide
Hardware Installation
You can directly connect up to 8 USB dongles to the dongleserver Pro.
1. Connect the USB dongle to a USB port of the UTN server.
2. Repeat step 1 if you want to connect more than one USB dongle.
3. Connect the network cable (RJ-45) to the UTN server.
4. Connect the power cord to the UTN server.
The UTN server boots and then is ready for use.
Important:
If required, you can connect up to 2 USB dongles via
cable with the UTN server.
Only use USB cables shorter than 3 meters.
All other USB dongles must be directly connected to the
USB ports.
dongleserver Pro
with
USB dongles
network
clients with software tool
'SEH UTN Manager'
UTN connection
To Next Page
Loading...
