SEH ISD300 - Page 14

ISD300 User Manual
ISD300 User Manual
Network Settings
14
Proceed as follows:
1. Press .
IP Setup|Cancel appears in the display.
2. Press to confirm.
IP Configuration appears in the display.
3. Select
Manual via .
4. Press to confirm.
IP Address:000.000.000.000 appears in the display.
5. Enter the IP address.
Use to navigate to individual numerical values within the IP
address. Change individual numerical values via .
6. Press to confirm.
Netmask:000.000.000.000 appears in the display.
7. Enter the netmask.
8. Press to confirm.
Gateway:
000.000.000.000 appears in the display.
9. Enter the gateway.
10. Press to confirm.
Apply|Back appears in the display.
11. Press to confirm.
The settings are saved.
Setting TCP/IP parameter automatically (DHCP) via panel
interface
Use the navigation keys on the panel interface to set TCP/IP
parameter via DHCP.
Proceed as follows:
1. Press .
IP Setup|Cancel appears in the display.
2. Press to confirm.
IP Configuration appears in the display.
3. Select
DHCP via .