Need help?Do you have a question about the Seko KRONOS 50 and is the answer not in the manual?
General| Brand | Seko |
|---|---|
| Model | KRONOS 50 |
| Category | Water Pump |
| Language | English |
Guidelines for safe and intended operation of the pump, specifying prohibited uses and user responsibilities.
Defines qualifications for technical, electrician, and instructed personnel based on training and experience.
Details the function of the transparent cover for preventing mechanical injuries and leakage.
Instructions on actions to take during an emergency, including power disconnection and chemical escape response.
Overview of the Kronos peristaltic pump, its technology, typical applications, and housing specifications.
Lists the main features of the Kronos pump, including power supply, output range, motor type, and connectivity.
Identifies and lists the various components of the Kronos pump based on numbered diagram labels.
Presents the physical dimensions of the device through diagrams and measurements.
Step-by-step guide for marking holes, drilling, and fixing the pump bracket to the wall.
Instructions for connecting the suction and discharge lines, including hose preparation and tightening.
Procedure for laying the power cable, ensuring safety, and connecting it to the terminal block.
Details terminal connections, descriptions, and electrical features for pump wiring.
Explains the function of each control key on the pump's operating unit for navigation and operation.
Describes how to access and navigate the pump's programming menu using control keys.
Details how to adjust specific parameters like language, password, and pump calibration.
Explains setting up manual dosing with ON/OFF/DELAY times and mA modes for proportional dosing.
Details configuration for PPM, 1:N, and N:1 dosing modes based on concentration, pulses, and speed.
Describes setting up batch dosing based on quantity and time, and starting/interrupting dosage.
Allows selection and configuration of various pump operating modes like Manual, mA, PPM, and Batch.
Allows setting chemical density and configuring input triggers for pump operation consent.
Configuration for measurement units, buzzer activation during alarms, and level alarm behavior.
Setting up the alarm relay status and defining the pump's maximum flow rate.
Provides a quick access menu for modifying key parameters like Max Flow Rate, N, Quantity, and PPM.
Comprehensive list of all settable parameters and a table detailing dosing parameters for different modes.
Step-by-step guide for safely removing and replacing the pump tubing using control keys.
Instructions for adjusting the contrast of the pump's LCD display using the control keys.
Explains the information displayed during pump operation, including mode, memory status, and message.
Describes the display status and available adjustments when the pump is in stop mode.
To Next Page
