Seko TEKNA EVO TPG - Setting the Language; Manual Dosage Programming; 0-4;20 mA Proportional Dosage

EM00136061
rev. 2.5
EN
3
Setting t
he Language
Programming
Operation
-
-
-
-
-
Pump Functions
Max flow rate
Alarm Relay
Language
P100%
N.Open
English
PROG
+
-
Makes it possible to select the language. The pump is set in
English in the factory.
Changes can be made by pressing the
key, then
using the
keys to set the new value.
Press
to
co
nfirm and return to the main menu
Paragraph 1
–
Manual Dosage
Programming
Operation
+
-
Pump Funtions
Configuration
Pump
Functions
PROG
The pump operates in constant mode. The flow can only be manually
regulated by pressing the
keys at the same time to increase
th
e flow, or the
keys to decrease it.
Display during Operation
Display during Setting (MODE key)
MAN
FFF
Lev Stop
P100%
Operating mode


Man = Manual
Alarms and statuses


Lev = Level alarm


Flw = Flow alarms
FLOW sensor
status
Pump status


Empty = pump in start


Stop = pump stationary


Paus = pump in pause
Current dosage
speed
(depends on selected unit of
measurement)


Percentage, Frequency,
l/h, Gph, ml/m
MAN
P100%
Operating mode


Man (during manual modification of the
flow it displays the corresponding
frequency value)
Current dosage value


Modify the maximum flow by pressing the
+ or
–
keys at the same time
Paragraph 2
-
Dosage Proportional to Signal 0/4
-
20
Programming
Operation
+
-
-
-
+
-
+
-
Pump Funtions
Configuration
Pump
Functions
0/4 - 20 mA
0/4 - 20 mA
0/4 - 20 mA
Low 4.0mA
High 20.0mA
PROG
The pump proportionally doses at a signal of (0)4
-
20 mA. On the basis of
the factory settings, the pump interrupts dosage at 4mA and doses at the
maximum set frequency when it receives 20 mA. These two values can be
modified during programming
. The maximum frequency can be modified
during operation, by pressing the
keys at the same time to
increase the flow, or the
keys to decrease it
.
www.winwinpoolshop.com