Seko TEKNA EVO TPG - Proportional to External Impulses (Division); Proportional to External Impulses (Batch Dosage)

EM00136061
rev. 2.5
EN
5
Display during Operation
Display during Setting (MODE key)
1:n
F
F
F
M
M
M
1
Lev Stop
0
Operating mode

1:n = impulse
multiplication
Alarms and statuses

Lev = Level alarm

Flw = Flow alarm

Mem = Memory alarm
FLOW
sensor
status
Programmed
value of n
Pump status

Empty = pum
p in start

Stop = pump stationary

Paus = pump in pause
Current dosage value

Displays stroke
countdown
Memory
function
status
Timeout n
0s 1
Displays
programmed
timeout
Current dosage value


Displays the value of n. This
can be modified by pressing
the + or
–
keys at the same
time
Paragraph 5
–
Proportional to External Impulses (division)
Programm
ing
Operation
+
-
-
+
-
Pump Funtions
Configuration
Pump
Functions
Divide (n:1)
n 4
PROG
Divide (n:1)
The pump doses in proportion to an external signal (i.e.: impulse launch
counter). At every “n” signals, the pump makes a strike. You can set the
value of “n” during programming. By programming the value of
“n” you set
the maximum dosage %. This value can be modified during operation, by
pressing the
keys at the same time to increase the flow, or the
keys to decrease it
.
Display during Operation
Display during Setting (MODE key)
N:1
F
F
F
4
Lev Stop
P100%
Operating mode

1:n = impulse
multiplication
Alarms and statuses

Lev = Level alarm

Flw = Flow alarm
FLOW
sensor
status
Programmed
value of n
Pump status

Empty = pump in start

Stop = pump
stationary

Paus = pump in pause
Current dosage value

Maximum dosage
percentage
n:1 6
6
P100%
Operating mode
Programmed value


Value of n
Current dosage value


The dosage % can be modified
by pressing the + or
–
keys at
the same time
Effective
value of “n”
Paragraph 6
–
Proportional to External Impulses (batch dosage)
Programming
Operation
+
-
-
-
-
+
-
+
-
+
-
Pump Funtions
Configuration
Pump
Functions
Batch mode (1:c)
Q.ty 10.0ml
Time 10s
Memory Off
PROG
Batch mode (1:c)
Batch mode (1:c)
Batch mode (1:c)
The pump doses in proportion to an external signal (i.e.: impulse
launch counter). In this case,
it is possible to set the quantity to be
dosed in ml and the time within which to complete dosage.
Dosage can be started manually by pressing the
key, or by
using a remote control. The
key interrupts dosage. The dosage
alread
y made
can be reset by pressing the
key, or started again
by pressing the
key again.
The quantity to be dosed can be modified during operation, by
pressing the
keys at the same time to increase the flow,
or the
keys to decrease i
.
www.winwinpoolshop.com