Seko TEKNA EVO TPG - Proportional to External Impulses (PPM Dosage)

EM00136061
rev. 2.5
EN
6
Display d
uring Operation
Display during Setting (MODE key)
Batch
FFF
MMM
7.0ml
Lev Stop
0
Operating mode


Batch
Alarms and statuses


Lev = Level alarm


Flw = Flow alarm


Mem= Memory alarm
FLOW
sensor
status
Programmed value


Quantity in ml
Pump status


Empty = pump in start


Sto
p = pump stationary


Paus = pump in pause
Current dosage value


Gradually displays
the dosed quantity
Memory
function
status
Q.ty 7.0ml
7.0ml
Operating mode


Displays in sequence: quantity to
be dosed, dosage time and pump
frequency
Dosage value


The quantity can be modified by pressing the
+ or
–
keys at the same time
Paragraph 7
–
Proportional to External Impulses (ppm dosage)
Programming
Operation
+
-
-
-
-
+
-
+
-
+
-
+
-
+
-
+
-
Pump Funtions
Configuration
Pump
Functions
ppm Mode
ppm 50
Pulse/l 4
Pulse/L 4
L/pulse 4
Conc(%) 100
Memory Off
PROG
ppm Mode
ppm Mode
ppm Mode
ppm Mode
ppm Mode
ppm Mode
-
The pump doses in proportion
to an external signal (i.e.:
impulse launch counter), automatically calculating the
relationship between incoming signals and pump strokes on
the basis of the programmed ppm value.
The data to be entered is the ppm value, the impulse/litre
ratio (or litre
/impulse) of the counter and the concentration of
the product to be dosed.
The dosage frequency can be modified during operation, by
pressing the
keys at the same time to increase
the flow, or the
keys to decrease it
.
Display during Operation
Display during Setting (MODE key)
Ppm
FFF
MMM
10
Lev Stop
F300s/m
Operating mode


ppm
Alarms and statuses


Lev = Level alarm


Flw = Flow alarm


Mem= Memory alarm
FLOW
sensor
status
Programmed ppm
value
Pump status


Empty = pump in start


Stop = pump stat
ionary


Paus = pump in pause
Current dosage value


Frequency
Memory
function
status
cc/stroke 1.0
0.23 F300s/m
Operating mode


Displays in sequence: cc/stroke,
impulses/minute on the counter and %
concentration of the chemical product
Dosage value


Programmed
ppm value


The dosage frequency value can be
modified by pressing the + or
–
keys
at the same time.
www.winwinpoolshop.com