-35-
CAUTION
• When using quad channels 17-32, it is not possible to terminate this mode unless a sub-
channel has been set (A, b, c or d is displayed).
6. Advanced Functions
3. The set channel number will blink at this time.
Turn the Jog wheel to set the channel setting.
4. In the Setting mode, “ch” appears on the ISO display area. At the same time, channel numbers
(1 to 16 and 17 to 32) appear on the F display area. When the channel number is 17 to 32, sub-
channel (A, b, c and d) settings are displayed on the T indicator. In the absence of settings,
“-” appears in the figures.
5. In sub-channel settings, after the channel is set to 17 to 32, the assigned buttons below are
pressed. Pressing each of the buttons activates or deactivates the sub-channels (A, b, c or d).
When a sub-channel is activated, the corresponding sub-channel letter appears on the display.
If a sub-channel is deactivated, a “-” is displayed in place of the letters.
↔ Each assigned button enables to set
sub-channel directly.
AVE./∆EV M.CLEARISO 2ISO 1
“A” “d”“c”“b”
To Next Page
Loading...
