Sekonic L-608 Quick Guide

Sekonic L-608
Quick Guide
LCD Display / Custom Settings
Sekonic L-608
To set Custom Settings (DIP Switch 4): Located in Battery Compartment.
1. Turn power off.
2. Open battery compartment door and set DIP Switch 4 (CS) to ON
(up position).
3. Turn power on. “CS” (Custom Settings) will appear in upper right
hand corner.
4. Use JOG WHEEL to select Custom Setting number (No.)-see chart below.
5. Press Mode Key to Select Item Number (Item #)-see chart below.
6. Set DIP switch 4 (CS) to OFF (this will turn power off automatically).
7. Replace battery compartment door and press power button on.
NOTE: Pressing M.CLEAR in CS mode will reset all settings to default (No. 0)
0123
1
Ambient
& Flash
ISO 2 Setting
Film Sensitivity
1/3 Step
Filter Setting 0.1
EV Step (–5.0EV)
--
2
Ambient
& Flash
Exposure Compensation Display Setting Always Display Not Displayed - -
3
Ambient
& Flash
Increments of Shutter Speed 1 Step 1/3 Step 1/2 Step -
4
Ambient
& Flash
Increments of Aperture 1 Step 1/3 Step 1/2 Step -
5 Ambient T Priority Mode Available Not Available - -
6 Ambient F Priority Mode Available Not Available - -
7 Flash Corded Flash Mode Available Not Available - -
8 Flash Auto-Reset Cordless Flash Mode Available Not Available - -
9 Flash Analyzing Measurement Available Not Available - -
*10 Ambient Luminance Display Not Available
Compund +
Individual
Compound Individual
11 Ambient Luminance Measurement in Incident Mode Not Available LUX FC LUX, FC
* Individual indicates that LUX and Footcandles (FC) will be displayed w/out f/s (or shutter speed) and Analog Scale.
Compound indicates that LUX and Footcandles will be displayed with f/s (or shutter speed) and Analog Scale.
Custom Setting List
Item
Custom Setting NameLightingNo.
Measuring
Modes Incident / Reflected
Spot Function Icons
ISO Display
Analyzed %
of Flash
Indicator
Luminance
Indicator
Exposure
Compensation
Memory/Multi
Flash Indicator
Battery
Indicator
Shutter
Priority
Indicator,
Shutter
Speed &
f.p.s Display
Analog Scale Digital Aperture Value, Aperture Priority, EV
Brightness Difference, Average Function, EV Display
Radio Trigger Mode
L-608 Quick Guide V3.p65 4/11/01, 9:28 AM1

Sekonic L-608 Specifications

General

Sensor	Silicon photodiode
Display	LCD
Memory Capacity	9 readings
Type	Light Meter
Measuring Modes	Incident, Reflected, Flash
ISO Range	3 to 8000
Aperture Range	f/0.5 to f/128
Power Source	2 AA batteries
Measuring Range (Incident Light)	EV -2 to 22.9 (ISO 100)