Need help?Do you have a question about the Sekonic L-608 and is the answer not in the manual?
General| Sensor | Silicon photodiode |
|---|---|
| Display | LCD |
| Memory Capacity | 9 readings |
| Type | Light Meter |
| Measuring Modes | Incident, Reflected, Flash |
| ISO Range | 3 to 8000 |
| Aperture Range | f/0.5 to f/128 |
| Power Source | 2 AA batteries |
| Measuring Range (Incident Light) | EV -2 to 22.9 (ISO 100) |
Learn how to lock and unlock the meter's settings to prevent accidental changes.
How to switch between incident and reflected light measurement modes.
Guide to selecting different measurement modes like shutter priority or aperture priority.
Configuration options using DIP switches for EV, Multi, Buzzer, and Custom settings.
Instructions for using the meter in incident light mode with the lumisphere.
Steps for performing spot metering with reflected light using the zoom lens.
Measure ambient light using Shutter Speed Priority, Aperture Priority, EV, or Cinematography modes.
Measure flash light using cord, cordless, cumulative, or wireless modes.
Store up to nine measured values for incident and reflected light.
Calculate the average of stored measurements.
Evaluate studio lighting and check lighting evenness.
Measure ambient light levels in Lux or Foot-Candle units.
Measure reflected light luminance in Cd/m² or Foot-Lambert units.
Apply precise +/- EV compensation for filters, bellows, or other needs.
Adjust meter calibration for specific requirements or other meters.
Compensate for filter effects on exposure readings.
Analyze the ratio of flash to ambient light for creative control.
Configure various settings like shutter/aperture increments or priority modes.
Trigger and measure flash output wirelessly using radio modules.
To Next Page
