Sekonic L-608 - Setting DIP Switches

-9-
4. Basic Operation
3. Setting DIP Switches
1. Switches for setting modes that are used infrequently are housed in the Battery compartment
of the meter. Select the mode you want prior to beginning measurements.
2. The DIP switches can be set by sliding the DIP switch !8 for the mode you want to select in the
ON position.
* EV settings
When DIP switch 1 is turned on, EV exposure readings are possible. (ambient light)
* Multi settings
When DIP switch 2 is turned on, multiple flash cumulative mode is possible.
* Buzzer setting
When DIP switch 3 is on, the buzzer sounds when light from a flash is received in the cordless
mode.
* CS setting (custom settings)
When DIP switch 4 is on, the mode changes to the custom setting mode, thereby enabling
various settings (refer to P33).
1 2 3 4