Sekonic L-608 - Basic Operation; Incident or Reflected Spot Measuring

-7-
4. Basic Operation
1. Incident or reflected spot measuring
1. To set for either incident or reflected light operation, turn the Incident / Reflected Spot Selector
Switch @8 on the eye piece, to the desired position ( or mark) until it clicks.
2. When incident operation is selected, the
mark will blink for three seconds and when Reflected
Spot operation is selected the
mark will blink for three seconds on the LCD.
NOTE:
• Before taking measurements, always make sure that the desired measurement mode
(
or ) is chosen by checking the LCD or that the Incident/Reflected Spot Selector
Switch is clicked in proper position.
Incident operation Reflected Spot operation
Incident operation Reflected Spot operation