-15-
1-3 EV mode
Open the Battery compartment cover !6 and slide the EV DIP switch 1 (see page 9) to the ON
position.
1. Hold down the Mode set button !0 and turn the
Jog wheel t to select
value mode.
2. Press the Measuring button !5 to make a
measurement. Release the Measuring button to
complete the measurement. The measured value
(EV value) at that time will be displayed.
At the same time, the shutter speed will be
displayed in the digital display area, and the
corresponding f stop will be displayed on the analog
scale.
While pressing the measuring button, the meter
measures continuously until it is released.
Reference:
•“E.u” (Exposure under) or “E.o” (Exposure over) on the T or F display area and “U”or “O” on
the analogscale appears when the combination of shutter speed and aperture are outside
the display range. Changing the shutter speed or aperture with the Jog wheel will allow you
to find a combination that is possible.
If the “E.u” or “E.o” readout and “U”or “O” on the analogscale blink, this indicates that the
light level is beyond of the measurement range of the light meter. Adjust the lighting in this
case.
f stop
Shutter
speed
EV value
5. Measurement
MODE
To Next Page
Loading...
