-14-
1-2 Aperture Priority mode
1. Hold down the Mode set button !0 and turn the Jog wheel
to select aperture priority mode
.
2. Turn the Jog wheel t to set the desired f stop
value.
3. Press the Measuring button !5 to make a
measurement.
Release the Measuring button to complete the
measurement. The measured value (shutter
speed) at the time will be displayed.
While pressing the Measuring button, the
meter measures continuously until it is
released.
Reference:
• It is possible to switch between full, 1/2 or 1/3 F stop values with custom settings.
• You can set aperture from 0.5 to F161. Please note that in 1/3 stop increments F0.56 is
displayed as
and F0.63 is displayed as .
• The L-608 displays the measured aperture value in either full or half stop increments on
the analog scale, while L-608 CINE displays it in either full or 1/3 stop increments.
• Readings outside the display range or beyond the measuring range are similar to the
previous instruction (see page 13).
• After measurement, the shutter speed corresponding to the F stop is displayed when the
F stop is changed.
5. Measurement
1/10
shutter
speed
Set f stop value
Measured value
(shutter speed)
MODE
Measured shutter speed
To Next Page
Loading...
