Sekonic SPEEDMASTER L-858D-U - Page 122


5. Measuring
NOTICE
Ɣ
7KHÀDVKGXUDWLRQWLPHDQGJUDSKDUHGLVSOD\HGLQWKH)ODVK'XUDWLRQ$QDO\VLV
Mode, however, they cannot be stored in the memory.
They are cleared if the Measuring Mode is changed or the POWER switch is turned
OFF.
Ɣ
The incident light measurement can only be used in Flash Duration Analysis Mode.
Ɣ
When the synchro cord is connected to the Synchro Terminal
⓬
or when the
meter's Power Button
❺
LVSUHVVHGWKHÀDVKPD\¿UH
Ɣ
$OVRWKHÀDVKPD\QRW¿UHZKHQWKHWULJJHUYROWDJHLVYHU\ORZ,QVXFKDFDVH
follow "5-4-1 Flash Duration Analysis Cordless Mode". 
¨
P98)
NOTE
Ɣ
:KHQWKHPHDVXUHGYDOXHGLVSOD\DUHDLVWRXFKHGERWKÀDVKZDYHIRUPJUDSKDQG
PHDVXUHGYDOXHDUHGLVSOD\HG:KHQLWLVWRXFKHGDJDLQWKHGLVSOD\UHWXUQVWRWKH
previous screen.
Measuring Screen
Flash Duration Analysis Mode
Flash Waveform Graph Screen
Touching the
Measured value
area changes
the display.
* The Graph Screen cannot be used to make measurements.
Ɣ
0HDVXUHWKHÀDVKOLJKWFKDUDFWHULVWLFVLQDGDUNURRPZLWKRXWDPELHQWOLJKW
Ɣ
7KHPHDVXUHPHQWFDQEHVWDUWHGLPPHGLDWHO\DIWHUSUHVVLQJWKHPHDVXUHPHQWEXWWRQ
DQGWKHWRWDOÀDVK¿ULQJWLPHFDQEHDFFXUDWHO\PHDVXUHG
,QWKLV)ODVK'XUDWLRQ$QDO\VLV&RUG0RGHWKHPHDVXUHGYDOXHPD\GLႇHUGHSHQGLQJRQ
WKHÀDVKZDYHIRUPDQGDQDO\VLVWYDOXHEHFDXVHPHDVXUHPHQWLVVWDUWHGDIWHUVHQVLQJ
WKHÀDVKOLJKW
&RUG)ODVK0RGH
&RUGOHVV)ODVK0RGH
Flash Duration Analysis Mode Flash
Waveform Graph Screen
Time lag until the start of
measurement
Flash Duration Analysis Cordless
Mode Flash Waveform Graph Screen