Sekonic SPEEDMASTER L-858D - Page 214

199
7. Hardware Setting
:KHQDGMXVWLQJWKHPHWHUEDVHGRQDPHDVXUHGYDOXH
obtained using another light meter>
1.
Touch the [User Calibration] Button.
The User Calibration Screen is displayed.
User Calibration Screen
>&ORVH@%XWWRQ
&DOLEUDWLRQ
Value
$GMXVWPHQW%XWWRQ

$GMXVWPHQW%XWWRQ
(-)
2.
Press the Measuring Button ❻ .
7KH8VHU&DOLEUDWLRQ6FUHHQDOORZV\RXWRPDNHPHDVXUHPHQWVWKXV\RXFDQHTXDOL]H
measured values obtained using another light meter under the same light source.
3.
$GMXVWWKHFDOLEUDWLRQYDOXH
7RXFKWKH$GMXVWPHQW%XWWRQ ) or ( ) to adjust the calibration value in
LQFUHPHQWVRI(9
4.
Touch [Close] Button.
Finish the setting, and return to the Hardware Setting Screen.
NOTICE
Ɣ
User calibration carried out in Hardware Setting is not displayed on the
status bar.
Ɣ
Note that the individual compensation is possible in the incident light
V\VWHPDQGUHÀHFWHGOLJKWV\VWHPZKLOHXQLIRUPFRPSHQVDWLRQLVDSSOLHG
in Ambient Mode and Flash Mode.