Sekonic SPEEDMASTER L-858D - Page 232

217
12. Troubleshooting
Condition Possible reasons What to do
&DQQRWXVHWKHPHPRU\ The Memory Function can't be
used in the following Measuring
Modes.
&RUG0XOWLSOH&XPXODWLYH
Flash Mode
&RUGOHVV0XOWLSOH&XPXODWLYH
Flash Mode
- Radio T
riggering Multiple
&XPXODWLYH)ODVK0RGH
- Illuminance/Luminance
Measuring Mode
Use the Memory Function in
modes other than those on the
left.
Is "Memory Full" displayed
when you press the Memory
%XWWRQ
❼
"7KHPHPRU\FDQEH
used 9 times.
,I\RXFDQWSXWWKHWKRU
later measured value into the
PHPRU\
FOHDUXQQHFHVVDU\
memory values on the Memory
&OHDU6FUHHQDQGWKHQPHDVXUH
and store the value again.
,V0HPRU\%XWWRQ
❼
set to
2))"
3UHVVWKH0(18%XWWRQ
❾
.
6HOHFW&XVWRP6HWWLQJ
6HOHFW21IRU0HPRU\%XWWRQ
（
¨
P43
¨
P193)
The EV is not displayed.
The EV value is displayed in the
following Measuring Modes.
- Ambient T Priority Mode
- Ambient F Priority Mode
- Ambient TF Priority Mode
$PELHQW+'&,1(0RGH
$PELHQW&,1(0RGH
Use a Measuring Mode which
displays the EV value.
The EV scale is not
displayed even though it
is selected.
The EV scale can't be displayed
in the following Measuring
Modes.
&RUG0XOWLSOH&XPXODWLYH
Flash Mode
&RUGOHVV0XOWLSOH&XPXODWLYH
Flash Mode
- Radio Triggering Multiple
&XPXODWLYH)ODVK0RGH
Use the EV scale in a Flash
0RGHRWKHUWKDQD&XPXODWLYH
Mode. The measuring value
scale (f-stop value) can be used
LQ&XPXODWLYH0RGHV
&DQQRWWULJJHUWKHÀDVK
in HSS Mode.
Is the synchro cord used to
FRQQHFWDQGPHDVXUH"
HSS measurements are only
DYDLODEOHZLWK&RUGOHVV)ODVK
Mode and Radio Triggering
Mode (with RT-GX only).
,Q&RUGOHVV)ODVK0RGHSUHVV
the camera's shutter release
button to trigger and measure
WKH+66ÀDVK