Sekonic SR-6500 - Interface Settings; Interface Settings 2-1. Setting Baud Rate; Setting Baud Rate; Setting Character Bit Length

To Next Page

To Previous Page

-34-

Connecting to a computer



RS-232C

Interface settings

2-1.

Setting baud rate

(1) Press the

switch to enter the menu mode.

(2) Use the

and

DOWN

switches to select the following parameters,

and press the

FEED/ENTER

switch.

(3) Use the

and

DOWN

switches to select [Baud Rate] setting,

and press the

FEED/ENTER

switch.

(“



” mark ﬂ ashes in the ﬁ rst column of the ﬁ rst line on the LCD.)

(4) Use the

and

DOWN

switches to set the value.

(5) Press the

FEED/ENTER

switch to save the setting value into memory.

(The ﬂ ashing “



” mark disappears from the LCD.)

(6) Keep pressing the

CLEAR/EXIT

switch until it returns to normal mode,

or press the

switch to return to normal mode.

Note) To continue interface setting

Instead of returning to normal mode in step (6), you can continue

setting various values by skipping steps (1) and (2).

Baud rate

setting values

• 9600 • 19200

• 38400 • 57600

• 115200

2-2

. Setting character bit length

(1) Press the

switch to enter the menu mode.

(2) Use the

and

DOWN

switches to select the following parameters,

and press the

FEED/ENTER

switch.

SR-3565(E).indd34SR-3565(E).indd34 2007-8-1610:19:082007-8-1610:19:08

Main Page

Sekonic SR-6500 - Interface Settings; Interface Settings 2-1. Setting Baud Rate; Setting Baud Rate; Setting Character Bit Length

Table of Contents

Related product manuals