Sekonic SR-6500 - Information Display Settings

-63-

Standby duration
1.
Press the
MENU
switch to enter the menu mode.
2.
Use the
UP
and
DOWN
switches to select the following parameters,
and press the
FEED/ENTER
switch.
3.
Use the
UP
and
DOWN
switches to select [Time for Standby] setting,
and press the
FEED/ENTER
switch.
(“

” mark fl ashes in the fi rst column of the fi rst line on the LCD.)
4.
Use the
UP
and
DOWN
switches to set the value.
5.
Press the
FEED/ENTER
switch to save the setting value into memory.
(The fl ashing “

” mark disappears from the LCD.)
6.
Keep pressing the
CLEAR/EXIT
switch until it returns to normal mode,
or press the
MENU
switch to return to normal mode.
Note)
(1) Releasing Sleep/Standby mode
Sleep/Standby mode will be cancelled in the following conditions.
• When an operation is entered on the panel screen.
• When a descending command is sent.
• When an error occurs.
• When loading paper on the hopper.
(2) Conditions in which Sleep/Standby mode cannot be attained
Sleep/Standby mode is not available in the following conditions.
• When displaying a menu on the panel screen.
• When an error occurs.
(3) Stacker cover open error cannot be detected in Standby mode.
Time for Standby
setting values
• None
• 1 - 60 (Minutes)
*Can be set in minute
increments.
Low power consumption settings

Standby duration
SR-3565(E).indd63SR-3565(E).indd63 2007-8-1610:20:222007-8-1610:20:22