Sel SEL-351A - Page 91

520 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Date Code 20010307 Overcurrent, Voltage, Synchronism Check, and Frequency Elements 3-37

SEL-351A Instruction Manual



)LJXUH6\QFKURQLVP&KHFN(OHPHQWV

Table of Contents

Cover1
MANUAL CHANGE INFORMATION3
Table of Contents7
Section 1: Introduction and Specifications9
- INTRODUCTION AND SPECIFICATIONS11
Section 2: Installation27
- INSTALLATION29
Section 3: Overcurrent, Voltage, Synchronism Check, and Frequency Elements51
- OVERCURRENT, VOLTAGE, SYNCHRONISM CHECK, AND FREQUENCY ELEMENTS55
Section 4: Loss-of-Potential, Load Encroachment, and Directional Element Logic105
- LOSS-OF-POTENTIAL, LOAD ENCROACH˜MENT, AND DIRECTIONAL ELEMENT LOGIC107
Section 5: Trip and Target Logic143
- TRIP AND TARGET LOGIC145
Section 6: Close and Reclose Logic159
- CLOSE AND RECLOSE LOGIC161
Section 7: Inputs, Outputs, Timers, and Other Control Logic193
- INPUTS, OUTPUTS, TIMERS, AND OTHER CONTROL LOGIC197
Section 8: Breaker Monitor and Metering243
- BREAKER MONITOR AND METERING245
Section 9: Setting the Relay277
- SETTING THE RELAY279
Settings Sheet309
- Identifier Labels (See Settings Explanations in Section 9)309
- Current and Potential Transformer Ratios (See Settings Explanations in Section 9)309
- Line Settings (See Settings Explanations in Section 9)309
- Instantaneous/Definite-Time Overcurrent Enable Settings309
- Time-Overcurrent Enable Settings309
- Other Enable Settings310
- Phase Inst./Def.-Time Overcurrent Elements (See Figures 3.1, 3.2, and 3.3)310
- Phase Definite-Time Overcurrent Elements (See Figure 3.3)310
- Phase-to-Phase Instantaneous Overcurrent Elements (See Figure 3.7)310
- Neutral Ground Inst./Def.-Time Overcurrent Elements—Channel IN (See Figures 3.8 and€3.9)311
- Neutral Ground Definite-Time Overcurrent Elements (See Figure 3.8)311
- Residual Ground Inst./Def.-Time Overcurrent Elements (See Figures 3.10 and 3.11)311
- Residual Ground Definite-Time Overcurrent Elements (See Figure 3.10)311
- Negative-Sequence Inst./Def.-Time Overcurrent Elements (See Figures 3.12 and 3.13)*312
- Negative-Sequence Definite-Time Overcurrent Elements (See Figure 3.12)*312
- Phase Time-Overcurrent Element (See Figure 3.14)312
- A-Phase Time-Overcurrent Element (See Figure 3.15)312
- B-Phase Time-Overcurrent Element (See Figure 3.16)312
- C-Phase Time-Overcurrent Element (See Figure 3.17)313
- Neutral Ground Time-Overcurrent Element—Channel IN (See Figure 3.18)313
- Residual Ground Time-Overcurrent Element (See Figure 3.19)313
- Negative-Sequence Time-Overcurrent Element (See Figure 3.20)*313
- Load-Encroachment Elements (See Figure 4.2)314
- Directional Elements (See Directional Control Settings in Section 4)314
- Voltage Elements (See Figures 3.21, 3.22, and 3.23)315
- Synchronism Check Elements (See Figures 3.24 and 3.25)316
- Frequency Element (See Figures 3.27 and 3.28)316
- Reclosing Relay (See Tables 6.2 and 6.3)316
- Switch-Onto-Fault (See Figure 5.3)317
- Demand Metering Settings (See Figures 8.11 and 8.13)317
- Other Settings317
- SELogic Control Equation Variable Timers (See Figures 7.23 and 7.24)317
- Trip Logic Equations (See Figure 5.1)319
- Close Logic Equations (See Figure 6.1))319
- Reclosing Relay Equations (See Reclosing Relay in Section 6)319
- Latch Bits Set/Reset Equations (See Figure 7.13)319
- Torque Control Equations for Inst./Def.-Time Overcurrent Elements320
- Torque Control Equations for Time-Overcurrent Elements321
- SELogic Control Equation Variable Timer Input Equations (See Figures 7.23 and 7.24)321
- Output Contact Equations (See Figure 7.26)322
- Display Point Equations (only on models with LCD—See Rotating Default Display in Sections 7 and 11)322
- Setting Group Selection Equations (See Table 7.4)322
- Other Equations323
- Settings Group Change Delay (See Multiple Setting Groups in Section 7)324
- Power System Configuration and Date Format (See Settings Explanations in Section 9)324
- Front-Panel Display Operation (only on models with LCD—See Section 11)324
- Event Report Parameters (See Section 12)324
- Station DC Battery Monitor (See Figures 8.9 and 8.10)324
- Optoisolated Input Timers (See Figure 7.1)324
- Breaker Monitor Settings (See Breaker Monitor in Section 8)324
- Local Bit Labels (only on models with LCD—See Tables 7.1 and 7.2)326
- Display Point Labels (only on models with LCD—See Rotating Default Display in Sections 7 and 11)328
- Reclosing Relay Labels (See Functions Unique to the Front-Panel Interface in Section€11)329
- Protocol Settings (See Below)330
- Communications Settings330
- Other Port Settings (See Below)330
- Protocol Settings (See Below)331
- Communications Settings331
- Other Port Settings (See Below)331
- Protocol Settings (See Below)332
- Communications Settings332
- Other Port Settings (See Below)332
- Protocol Settings (See Below)333
- Communications Settings333
- Other Port Settings (See Below)333
Section 10: Serial Port Communications and Commands335
- SERIAL PORT COMMUNICATIONS AND COMMANDS337
Section 11: Front-Panel Interface (only on models with LCD)377
- FRONT-PANEL INTERFACE (ONLY ON MODELS WITH LCD)379
Section 12: Standard Event Reports and SER395
- STANDARD EVENT REPORTS AND SER397
Section 13: Testing and Troubleshooting423
- TESTING AND TROUBLESHOOTING425
Section 14: Appendices435
- APPENDIX A: FIRMWARE VERSIONS439
  - Determining the Firmware Version in Your Relay439
  - Firmware Revision History Table439
- APPENDIX B: FIRMWARE UPGRADE INSTRUCTIONS441
- APPENDIX C: SEL DISTRIBUTED PORT SWITCH PROTOCOL447
  - Settings447
  - Operation447
- APPENDIX D: CONFIGURATION, FAST METER, AND FAST OPERATE COMMANDS449
- APPENDIX E: COMPRESSED ASCII COMMANDS461
- APPENDIX F: SETTING NEGATIVE-SEQUENCE OVERCURRENT ELEMENTS469
- APPENDIX G: SETTING SELogic® CONTROL EQUATIONS477
- APPENDIX H: DISTRIBUTED NETWORK PROTOCOL (DNP) 3.00489
- APPENDIX I: USING THE SEL 251 AND SEL 267 RELAY SETTINGS IN THE SEL 351A RELAY505
- APPENDIX J: SEL-5030 acSELerator511
SEL-351A RELAY COMMAND SUMMARY513
SEL-351A RELAY COMMAND SUMMARY517

Related product manuals

Preview: Sel SEL-351S

Preview: Sel SEL-300 Series

Sel SEL-300 Series

Preview: Sel SEL-487E-3

Preview: Sel SEL-751

Preview: Sel SEL-751A

Preview: Sel SEL-487B

Preview: Sel SEL-487E-5

Sel SEL-400 Series

Preview: Sel 411L