To Next PageTo Next Page
Need help?Do you have a question about the Sel SEL-487B and is the answer not in the manual?
Dynamically assigns input currents to differential elements without auxiliary relays.
Assigns correct current values to differential elements based on user-defined conditions.
Achieves end-zone protection using SELOGIC control equations for user-defined conditions.
Provides three independent check zones to monitor incoming sources and outgoing feeders.
Includes six independent current differential elements with fast operating times for internal faults.
Monitors differential zone restraint and operating current for open/shorted CT conditions.
Consists of phase undervoltage/overvoltage and negative/zero-sequence overvoltage elements.
Includes complete breaker failure protection with retrip for each of the 21 terminals.
Offers 10 time-overcurrent curves and instantaneous/definite-time overcurrent elements.
Monitors disconnect open/close contact relationship and interprets auxiliary contact combinations.
Details three tie-breaker schemes using CTs configured in overlap or across the breaker.
Relay stores six settings groups to cover various protection and control contingencies.
Shows example configurations for double bus, breaker-and-a-half, and multiple busbar systems.
Synchronizes relays using IRIG-B or IEEE 1588 PTPv2 for accurate time-stamping.
Uses Simple Network Time Protocol for cost-effective synchronization via Ethernet.
Utilizes IEEE 1588 PTPv2 for high-accuracy timing over Ethernet networks.
Supports remote data acquisition and control functions using various communication protocols.
Enables remote analog and digital data acquisition over an IEC 61158 EtherCAT TiDL network.
Enables advanced relay logic programming using equations, inputs, outputs, and custom aliases.
Software for offline settings development, configuration, and analysis of relay settings.
Provides bidirectional relay-to-relay digital communication for enhanced coordination and tripping.
Provides Ethernet communication capabilities for Telnet, FTP, IEC 61850, and DNP3 LAN/WAN.
Enables remote access to relay settings, metering, and event reports via Ethernet.
Offers DNP3 Level 2 slave functionality over Ethernet for SCADA communication.
Supports IEEE 1588 PTPv2 for data time synchronization over Ethernet networks.
Provides seamless recovery from Ethernet network failures according to IEC 62439-3.
Serves read-only web pages for relay status, settings, and metering information.
Enables interoperability using logical nodes for substation monitoring and control.
Supports file transfers within an MMS session for IEC 61850 data.
Requires authentication for MMS sessions to enhance security.
Software to manage logical node data for IEC 61850 devices on a network.
Features LCD screen, LED indicators, and pushbuttons for local control and status monitoring.
Describes standard and optional front-panel LEDs for indicating status and trip events.
Allows customization of target LED and pushbutton functions using labels and software.
Details the relay's input and output capabilities, including standard and high-current interrupting contacts.
Provides primary/secondary current, voltage, PT/CT ratios, and zone information.
Aids post-fault analysis with event reports, oscillography, and concise event summaries.
Monitors substation battery voltage, alarms, and dual ground detection for DC quality.
Illustrates the standard front panel layout including LCD, pushbuttons, and target LEDs.
Shows the optional expanded front panel with more LEDs and programmable pushbuttons.
Provides detailed dimensions for rack-mount and panel-mount chassis configurations.
Covers compliance, inputs, outputs, power supply, and control specifications.
Details communication ports, time synchronization, and related specifications.
Lists physical dimensions, environmental ratings, and electromagnetic compatibility.
Covers data reporting, processing, element pickup ranges, and accuracies.
Details metering accuracy, voltage elements, and battery monitoring functions.
General
