To Next PageTo Next Page
Need help?Do you have a question about the Selbit ANP-05 and is the answer not in the manual?
General| Brand | Selbit |
|---|---|
| Model | ANP-05 |
| Category | Controller |
| Language | English |
Details on cutting the mounting hole and preparing the main board for controller installation.
Caution regarding potential electric shock during electrical assembly operations.
Instructions for mounting and connecting the TSS-8/001 power transformer.
Guidance on mounting the DPZ-320 anti-disturbance choke for correct operation.
Procedure for mounting the MSK-320 sensor and magnetic tape for precise measurement.
Connecting wires for head motion control contractors for increase/reduce functions.
Steps to connect prepared cables and assemble the controller casing.
Verifying all connections are correctly made before initial startup.
Checking and setting the input divider value using the calibr button and keypad.
Procedure for entering and calibrating the 'Real size' dimension for accurate measurements.
Steps for performing auto-calibration to ensure correct control system operation.
Manual and automatic control of saw spacing using keypad and fast dimension buttons.
Identifying and resolving error messages and operational issues encountered with the adjuster.
Best practices for optimal cutting parameters and controller maintenance.
Information regarding the controller's compliance with electromagnetic compatibility norms.
