Selecta Incudigit-TFT 2001261 - PROGRAMMING Screen; Programming Temperature Profiles

INSTRUCTION MANUAL CODE 80386 REV A FEBRUARY 2020 Page: 22
J.P. SELECTA s.a.u. Autovía A-2 Km 585.1 Abrera 08630 (Barcelona) España Tel 34 937 700 877 Fax 34 937 702 362
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
7.4 PROGRAMMING screen
Go to PROGRAMMING screen to:
• Set the temperature proles.
• Set the timed operation for a prole.
(For instance, you can set a time and a week day to start a prole. As:
start, prole n
er
1 on Sunday at 19h00’)
7.4.1Programmingatemperatureprole:
A temperature prole is a sequence of steps, also called “dells”.
To go from the end of a «dell» to the following «dell», it could be done in
two ways:
- With a «temperature ramp».
(go from 100ºC to 200ºC following a ramp at 2ºC per minute).
- As fast as possible, “--” indicator (maximum power).
Prole parameters input:
• Select the prole number between 0 and 10 with .
• Press on the parameter to be modied. (Temp, ramp, length ...)
• Press on these icons: to enter the value.
• Modify another parameter.
Special values:
• If you enter value OFF in temperature (you have to press Increase key)
and the next steps are disabled and not executed.
• If you enter INF in Step length, the oven remains permanently at this
temperature.
• If you enter -- in the ramp, the oven makes the temperature rise at the
fastest speed possible.
Starting of temperature prole
• To set the prole starting time, press on «—:—» (09:00 in the picture).
• Enter time by pressing in hh:mm format.
• Press on the days of the week when the prole should be run.
• Accept the programming by pressing on .
Note: If you run a timed program, do not forget to press the RUN key to start
the program. During the timeout, it will indicate that it is in Standby mode.
Prole
num.
1-10
Segment
Temp.
ºC
Dell
duration
hh:mm
Ramp
ºC/mi-
nute
Prole
start