Seltron DD2+ - Selection Between Heating or Cooling; Switching Modes; Setting the Day and Night Temperature; Day Temperature Setting

ENG
USER MANUAL
11
Night temperature
Hold key ( ) for approx. 5 seconds (Picture 6a). Release
key after you hear a beep. Now press key or to set the re-
quested night temperature (Picture 6b). To save and quit setup,
press key ( ) once again.
Picture 6b
Picture 6a
Picture 5
Day temperature
Turn knob to set the requested
day temperature between 10 °C
and 30 °C (Picture 5).
Setting the day and night temperature
Selection between heating or cooling
To switchover between heating and cooling and in reverse, hold
key for approximately 15 seconds (Picture 4a). Release key
after you hear a beep. The display writes out active mode for a
few seconds, HEA- heating or cOO- cooling (picture 4b).
Picture 4a
Picture 4b