ENG
INSTALLATION MANUAL
26
Picture 21
Always connect the auxiliary tem-
perature sensor into the connector
terminals 3 and 4 on wall DD2+
plate (Picture 21). Set the parame-
ters for this sensor in service group
S1. Telewarm for remote activa-
tion, can also be connected in the
same terminals.
Connecting the auxiliary temperature sensor
On the DD2+ can be connected only MURATA type sensors. This
sensors are:
- outdoor sensor AF/M,
- room sensor PS10/M,
- immersion sensor TF/M.
Connecting the Telewarm
Connect Telewarm G1-D into the terminals 3 and 4 on the DD2+
wall plate (Picture 21).
To learn more about connecting the Telewarm on electric and
telephone network see User manual for Telewarm.
To Next Page
Loading...
