Seltron RCD1 - One-Time Domestic Hot Water Warming Function (RCD2 Only); Fireplace Function (RCD2 Only)

| 13Instructions for use
EN
OPERATION MODE SELECTION
(RCD2 ONLY)
ONE-TIME DOMESTIC HOT WATER WARMING
FUNCTION (RCD2 ONLY)
FIREPLACE FUNCTION (RCD2 ONLY)
Function enables that we can turn one-time d.h.w. heating to the requested temp. at
any time. The function is automatically turned o when domestic hot water is warm or
after one hour. Function can be activated by pressing the button .
Now we can change the requested temp. of domestic hot water by pressing button
and . Change the setting while the value is flashing. By pressing the button again,
return to the basic display. One-time domestic hot water function can be turned o
before expiration by pressing .
Requested d. h. w. temp.
One-time d. h. w. warming function display
The Fireplace function enables temporary shut-down of room temp. eect on room
heating regulation. This function is turned on when we make a fire in the fireplace in
the living room which has the room unit. This prevents to reduce the temp. levels in
other rooms due to increase of temp. in the living room.
Function can be activated by pressing the button for 10 seconds.
Operation of fireplace function is indicated by the flashing symbol .
Fireplace function works at least for the amount of time set with parameter S1.13. After
expiration of time, it works until the measured room temp. is higher than the requested
room temp. that is set.
Fireplace function can be turned o before expiration of time by pressing again the
button for 10 seconds.
By pressing , any setting can be terminated at any time, and we can return to
the basic display.