What to do if Selve Engine motor stops automatically when moving UP and reverses?
If your Selve Engine stops automatically and reverses while moving UP, it's likely due to the overload recognition being triggered. First, remove any obstructions and check the curtain path. If the issue persists, consider selecting a stronger motor.
How to troubleshoot Selve Engine motor that does not work?
If your Selve Engine motor isn't working, begin by checking the electrical connection to ensure it's properly connected. If the motor still doesn't work, the thermal protection switch may have been activated. In that case, wait for 5 to 20 minutes to allow it to reset.
Why does Selve Engine motor stop automatically when moving DOWN and reverses?
If your Selve Engine stops automatically and reverses when moving DOWN, it indicates that the blockage/obstacle recognition has been triggered. Remove any obstacles and carefully inspect the curtain path to ensure it is clear.
How to fix Selve Engine when UP and DOWN directions are switched?
If the UP and DOWN directions are switched on your Selve Engine, it could be due to incorrectly set end positions; try resetting them. Another potential cause is the black and brown wires being connected to the switch incorrectly. If so, switch the wires, ensuring black is for rotation right and brown is for rotation left.
Important safety notes for installation and operation, detailing risks and precautions.
Specifies the intended purpose of the SEE drive type for operating roller shutters only.
Details the drive's operational characteristics including limit programming and obstacle detection.
Step-by-step guide on mounting the motor into a shaft using appropriate adapters.
Explains methods for supporting the motor, including using squares, flanges, or mounting plates.
Instructions for connecting and disconnecting the motor's pluggable cable safely.
Diagram and explanation of the electrical wiring for the motor connection.
Describes the motor's behaviour upon first power-up and the initial operation sequence.
How to perform initial operation using the SELVE setting switch and its connections.
Procedure for setting, deleting, and storing the lower and upper end positions manually.
Detailed steps for setting upper and lower end positions in manual setup mode.
Instructions on how to reset the motor's end positions and settings.
Provides detailed technical specifications for different SELVE motor series.
Declaration of conformity statement regarding relevant EU directives for the SEE motor.
Lists common problems, their causes, and solutions for the SELVE motor.
Contact information for SELVE customer support and resources for further assistance.
To Next Page
General
