What to do if Selve Engine drive does not work?
If your Selve Engine drive isn't working, there are a couple of things you can check. First, examine the electrical connection to ensure it's properly connected. If that's not the issue, the thermal protection switch might have been triggered. If this is the case, wait 5 to 20 minutes before trying again.
Why Selve SEL Plus Engine drive has stopped automatically when moving UP?
If your Selve Engine drive stops automatically when moving up, it's likely due to the overload recognition being triggered. To resolve this, remove any obstructions, check the curtain path, and consider selecting a stronger drive if necessary.
Why Selve SEL Plus Engine drive has stopped automatically when moving DOWN?
If your Selve Engine drive stops automatically when moving down, the blockage/obstacle recognition has likely been triggered. Remove any obstacles and check the curtain run to fix this.
What to do if UP and DOWN directions are switched on Selve SEL Plus?
If the UP and DOWN directions are switched on your Selve Engine, it indicates that the end positions were set incorrectly. Reset the end positions to correct this.
How to fix Selve SEL Plus Engine drive if it does not perform a short drive at initial commissioning?
If your Selve Engine drive doesn't perform a short drive during initial commissioning: 1. Check the electrical connection to ensure it is properly connected. 2. If the connection is correct, the end positions might already be set. In this case, reset the drive to its delivery state.
Specifies the intended application for the SELVE drives.
Details technical features of SEL Plus and SES motor types.
Step-by-step guide for fitting the drive into a shaft.
Explains methods and brackets for motor support.
Instructions for connecting and disconnecting the patch cord.
Wiring diagram and connection points for electrical setup.
Describes the motor's state upon delivery, with no learned positions.
Outlines methods for setting end positions using switches.
Discusses mechanical prerequisites for end position setting.
Provides a table comparing settings for SEL Plus and SES drives.
Details the automatic end position setting process.
Explains manual setting for bottom and top positions.
Describes manual setting for bottom position and automatic top stop.
To Next Page
General
