Selve SEL Plus - English

17
GB
Dear Customer,
by purchasing a SELVE electronic drive you have decided in favour of a quality product
from the SELVE company. This instruction manual describes the installation and ope-
ration of the drive. Make sure to read this handbook before commissioning of the
SELVE drive and adhere to the safety instructions.
After publication of the operating instructions, SELVE shall not be liable for any changes
to norms and standards! Subject to change without prior notice!
1. Safety instructions ............................................................................................ 18
2. Information about the drive features .............................................................. 19
2.1. Designated use ............................................................................................19
2.2. Drive type features ..................................................................................... 19
3. Installation and electrical connection ............................................................. 20
3.1. Installation of the drive into a shaft .......................................................... 20
3.2. Supporting the motors .............................................................................. 21
3.3. Assembly and disassembly of the patch cord ......................................... 22
3.4. Electric connection .................................................................................... 22
4. Setting of the end positions ............................................................................. 23
4.1. Delivery status ............................................................................................ 23
4.2. Setup functions .......................................................................................... 23
4.3. Mechanic requirements ............................................................................. 24
4.4. Selection table for settings ....................................................................... 24
4.4.1. Automatic setup-mode .................................................................... 25
4.4.2. Manual setup-mode, two positions ............................................... 26
4.4.3. Manual setup-mode, bottom position – top stop .......................... 27
5. Reset .................................................................................................................. 28
6. Technical data ................................................................................................... 28
7. General declaration of conformity .................................................................. 28
8. Troubleshooting ................................................................................................ 29
9. Notes .................................................................................................................. 30
Contents